You are using an older browser version. Please use a supported version for the best MSN experience.

Harbor Freight recall replacement jack stands may be unsafe too, report says

Roadshow logo Roadshow 6/12/2020 Kyle Hyatt
a red stop sign sitting on the side of the road: This three-ton jack stand failed at much less than its rated weight. Mike Galli via Facebook © Provided by Roadshow This three-ton jack stand failed at much less than its rated weight. Mike Galli via Facebook

Remember when we published a story on Harbor Freight's jack stands being recalled because their locking pawls weren't fully engaging? It turns out that the replacement jack stands may have issues too -- big ones.

Research

According to a report published Friday by The Drive, the problem involves a customer who attempted to support his Volkswagen Golf with a set of new three-ton Harbor Freight jack stands, only to have one of them split down the middle. Yes, you read that correctly.

The splitting welds are likely the result of improper welding done at the factory, where the weld doesn't achieve full penetration and therefore doesn't fully secure the two pieces of metal. Needless to say, this is not something you should see on a three-ton jack stand with a Golf sitting on it.

Harbor Freight didn't immediately respond to Roadshow's request for comment.

The post-failure photos of the jack stand are pretty gnarly and would serve as plenty of evidence that maybe we automotive enthusiasts should start purchasing our safety-critical garage equipment elsewhere.

Also, if you haven't checked your jack stands (PDF) to see if they're a part of the Harbor Freight recall, do so at that link, and check over your replacements carefully before trusting your life to them.

This was originally published on Roadshow.

AdChoices
AdChoices

More from Roadshow

Loading...

image beaconimage beaconimage beacon